Hi Friends!
I hope
you have had a relaxing weekend so far! My hubby and I were
able to relax this afternoon and, of course, I had to take time a card since stamping and designing are one of
my favorite ways to relax.
I decided to hand tear the curved edge for the sketch and the sentiment is covering part of the curve (but I think you can still see it :-)).
If you have not already visited the above sites, I hope you will have a chance to do so- both sites have wonderful Design Team samples and entries!
To create
this card:
Using
Stāz-On® Jet Black Ink, stamp the anchor scene from Anchor the Soul(ODBD) set
onto Very Vanilla cardstock and color with Stampin’ Write Markers- Soft Sky,
Sahara Sand, Smoky Slate, Blushing Bride, Pink Pirouette and Baked Brown Sugar.
Use Clear
Wink of Stella® to add a bit of glimmer to the sand, seashells and anchor
and die cut with the Big Shot™ and Double Stitched Circle Dies (ODBD).
Die cut
another circle (the same size) with the Double Stitched Circle Dies (ODBD) from
Basic Black cardstock, split the Basic Black circle in half and adhere the
focal image to the black circle halves.
Sponge
Ranger® Tim Holtz® Tea Dye Distress Ink over the edges and use the Color
Spritzer Tool with the retired Stampin’ Write Baked Brown Sugar marker to add
distressing over the sand area and sky area.
Trim a
piece of Typeset Designer Specialty Paper, mount onto a piece of Basic Black
cardstock, sponge Ranger® Tim Holtz® Tea Dye Distress Ink over the edges and
mount onto the Whisper White card base.
Cut three
strips of the Going Places Designer Series Paper, hand tear the lower edge to
create a curve for the sketch, distress the edges with the Distressing Tool, mount
onto Basic Black cardstock and sponge Ranger® Tim Holtz® Tea Dye Distress Ink over
the edges.
Mount the
three strips onto the card front (the center strip flush to the card front and
the two side strips with dimensional foam).
Tea stain
a piece of 1 ¼” Burlap Ribbon (cut the edges off , pull apart and tea stain
using Ranger® Tim Holtz® Tattered Twigs Distress Stain (spritzing water over
the stained burlap ribbon and drying carefully with the Heat Tool).
Add the
burlap to the card front and mount the focal image using dimensional foam.
Use the
Embossing Buddy® to prepare a scrap piece of Very Vanilla cardstock and a piece
of Basic Black cardstock.
Stamp the
sentiment from Anchor the Soul with Versamark™ ink and stamp onto the Basic
Black cardstock, apply Stampin’ Emboss® White Embossing Powder and heat set
with the Heat Tool. Once the embossing
has cooled, trim the panel close to the sentiment.
Ink the
seashells from Beyond the Sea (Artistic Outpost) using Versamark™ Ink and stamp
onto the prepared piece of Very Vanilla cardstock, apply Stampin’ Emboss® Black
Embossing Powder and heat set with the Heat Tool.
Once the
embossing has cooled, color the seashells with Stampin’ Write Markers (Sahara
Sand and retired Primrose Petals) and carefully cut out the seashells.
Knot a length
of Hemp Twine, apply Ranger® Tim Holtz® Tattered Twigs Distress Stain (spritzing
water over the stained burlap ribbon and drying carefully with the Heat Tool)
to tea-dye the twine, twist the ends to fray the twine and mount onto the card
front.
Add the
sentiment to finish off the card.
Stamp Sets: Anchor
the Soul (Our Daily Bread Designs), Beyond the Sea (Artistic Outpost)
Ink: Stāz-On® Jet Black, Stampin’
Write Markers-Blushing Bride, Pink Pirouette, Soft Sky, Sahara Sand, Smoky
Slate, retired Baked Brown Sugar; Ranger® Tim Holtz® Tattered Twigs Distress Stain,
Ranger® Tim Holtz® Tea Dye Distress Ink, Clear Wink of Stella®
Paper/Cardstock: Very Vanilla, Basic Black; Typeset Specialty
DSP, Going Places DSP
Accessories: Big
Shot™, Double Stitched Circle Dies (ODBD), Sponge Dauber, Embossing Buddy®,
Stampin’ Emboss® White and Black Embossing Powder, Heat Tool, Color Spritzer
Tool, 1 ¼” Burlap Ribbon, Hemp Twine, Distressing Tool
Thanks again for stopping
by- it is true, with Christ as our Savior and Anchor, we can go through life’s roughest storms!
Have a blessed week,
my friends!